Posted by Absent Minded Farmer on August 03, 2020 at 14:36:13 from (75.128.194.76):
In Reply to: Today's funny posted by jon f mn on August 03, 2020 at 03:24:46:
I turned a lot of ground in my grandma's garden with a 2+2 & 7 bottom Deere plow or the Eska 560 & 3 bottom FH plow. Disked with the 470 wing disk. Those were my two favorite outside toy tractor jobs. Grandma liked the job I did as it kept the weeds down around the outside of the garden. Had a Nylint tractor trailer to haul it to & from the house. Used the Tru Scale Scout to get back home. All my hay was made in house. The pickup on the little IH baler is still full of fuzz from the shag carpet. It all went in the barn my grandpa made for me. It was the last thing he built before the Parkinson's got too bad. It is my most treasured farm toy.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
