Posted by Stephen Newell on August 10, 2020 at 04:59:11 from (107.77.198.66):
In Reply to: Chev gas filler posted by john-mi on August 09, 2020 at 16:29:47:
Changing the filter isn't difficult. If the filter is getting plugged up with rust then your gas tank is probably rusting and left unchecked could rust through where it would leak. You would need to remove the gas tank and clean out the tank with phosphoric acid. Put some nuts and bolts in the tank while you do it to break loose any loose particles. Once it has been rinsed out and dry coat the inside of the tank would need a fuel tank liner to prevent it from rusting again. It's like pouring a quart of paint inside the tank and you tip the tank at all angles to insure 100% coverage. Then pour out the excess and allow the liner to dry. Of course to do this you have to remove the fuel pump and sending unit so it just the sheetmetal tank you are working on. If it were me I would plan on putting in a new fuel pump at the same time.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
