Posted by oldproudvet on August 18, 2020 at 19:48:42 from (74.127.150.206):
In Reply to: Hornets posted by Dieseltech on August 18, 2020 at 09:50:13:
Ya stole my question guy! Just started writing it when in popped yours. I have 2 of them. One under a running board on an 830CK Case and the other in a 20 ft oak log I pulled out the woods last winter. With the tractor, I hopped up on the seat, was warming the glow plug and got mobbed, being on the backside of 75 I think I baled from the tractor quite quickly with only a dozen or so stings. The opening in the nest is straight down so you have to lay on the ground to even see the thing, let alone attack it. The next day, i went out to block an oak log for splitting and stacking. It is sitting on a row of 10 ft logs maybe 2 ft off the ground. I cut halfway thru on my first cut and was mobbed again, only standing on the ground I made a get away with only a couple of stings. The opening in the log, is a round hole, a broken off branch long ago, that has hollowed, and of course straight down. That one I may pick the log up with the skidder and rotate it 90 or a 180 degrees to get a better attack angle. I don't pop off the ground quite like I used to. Any ideas, not discussed below, particularly the Case deal, since the hive is really tucked into the corner of the floor boards. Oh, I too, found out that wasps post guards and they are active all night..... Thanks for your 2 bits guys. Larry
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
