Posted by fixerupper on August 27, 2020 at 15:57:44 from (108.161.63.205):
Out of all the responses only two of you guys mentioned using a two banger. All through the 50's and 60's our neighborhood baler guy had a two banger on the baler. First two banger was a 60 pulling a Case hand tie wire tie baler with the famous Wisconsin. I barely remember the Case baler as I was too young at the time. Second baler was a Deere 14t still pulled by the same 60 but sometime in the early sixxties the 60 was replaced with a 730 gas and the 14T was replaced with a 24T. In 1969 a new 4020 replaced the 730 and we thought we had died and gone to heaven. The 4020 was heavy and strong enough to not pull down with every plunger stroke so we could keep the bales stacked straighter on the rack. With a two banger on the baler the bales tended to start leaning forward on the rack. We did not have backs on the racks. We quit replacing PTO knuckles when the 4020 came into service. The 4020 was later replaced with a 4030, the first gen 2 Deere I had seen so it was an early one. A 336 baler came into play toward the end. After that we got smart and used large rounds.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Usin Your Implements: Bucket Loader - by Curtis Von Fange. Introduction: Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he rea
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
