Posted by old-9 on September 03, 2020 at 16:02:57 from (71.222.223.189):
Pretty warm here today, needed to do a little mowing. As the little Kobota BX was easy out ( the Ford was parked in the back) I drove it. Went along fine for the first round, then BANG ran over something! Turned out to be the top link pin worked loose and I ran over it. I could not believe that a mower blade could not only bend a pin but also take a chunk out of it. Well no harm no foul went back to mowing. Got 2/3rds done and time for a break, drove up to the shop and turned the Kubota off NOT!! The darned thing kept running! Well I do not know much about diesel engines but, I did know it has an electric fuel pump,no problem, took the ground off the battery it should run out of fuel right? Not! I called a dealer he suggested a few things that did not work, one was unplug the fuel pump still runs, I put a hose clamp pliers on the fuel line,still runs! It ran on the trailer 40 miles to the dealership ( they had a bet if it would be running when I got there). One of the mechanics had it stopped in about 10 seconds. An electric solinoid was bad! Oh well a few hundred to fix will have it back next week. Now I have to finish with the Ford. joe, poorer but wiser
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
