Posted by jimg.allentown on September 05, 2020 at 16:48:46 from (70.15.42.177):
In Reply to: Point gap questions posted by Repairman60 on September 05, 2020 at 13:52:48:
Anything you change or adjust in the distributor has some effect on timing and dwell. BUT, the effect of points gap on timing is slight. Standard procedure for engine tune up was to replace points and condenser, set dwell with a dwell meter, and then reset timing to correct spec. Some things that you do NOT do are trying to set timing by adjusting points or setting timing before setting dwell.
Another thing to pay attention to is lubricating the distributor cam and the rubbing block on the points. A small dab of white lithium grease is recommended. Failure to lubricate this critical wear point usually results in the points gap closing up as you run the engine. When the gap gets too small, the engine stops - wherever you are and no matter the time. Murphy's law usually dictates that this will occur at your farthest point from tools or assistance.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - 12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.