Posted by Case Nutty 1660 on September 18, 2020 at 17:19:08 from (75.127.27.51):
In Reply to: Ytdot Alert posted by texas cowboy on September 17, 2020 at 20:05:08:
Tony,, you have to take things said here with a grain of salt, or maybe a 50lb block of salt,, you and I both do things and have for many decades some here will never being to understand and will never think its safe to do so,, I have over a million miles in the seat of a semi hauling heavy equipment, plowing snow in blizzards, running cats fighting fires ect that would make most crawl in a corner and cower from,, was it dangerous heck yes it was at times,, and for many it would have been a no go as they flat out have no ability to handle the situations that can arise in time,, are we perfect nope not even but even so I have always been able to do things safely few others would even consider doing Nor would I want them to even try,, as I have always said anyone can drive something but there are Damn few real operators out there and getting less all the time,, I have done things in a twin screw end dump plowing snow that would send most to the funny farm,, many many times that was do to the total incompetent drivers on the road in cars and pickups,, most folks are not capable of multitasking,, and to do what I do it is a requirement and is not for a green horn,, driving truck is just one job I have done and it was done far less than operating all forms of equipment from Ag to heavy equipment building oil well locations damns and road building,, I can take a twin engine scraper and do things 99% would not even consider possible,, a front end loader and backhoe I am even better at,, not saying this to pound my chest and blow smoke either,, I have been in many equipment rodeo competitions and have the trophy's to prove my worth as well as thousands of hours in about any piece of equipment we have up here,, I say all of this not to brag but to prove a point, many of the comments below are correct for a average person who "can drive it" a Real operator is in a skill set and level all their own and does not fall into the same average Joe category most people are used too, That said the load you have to me is average at best and noting you cant handle, I hope things are going Well for you and yours as we have not chatted in a while cnt
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Fordson F Ignition System - by Anthony West. A fellow restorer contacted me earlier this year asking for some help and advice on a model F that he was restoring. He had over a period of months spent a fair amount of his hard earned cash on replacement parts for the old "trembler" ignition. Sadly though all his efforts seemed to be a waste of time and money as he still couldn''t get the temperamental old thing to run correctly!! If i said that this was a little frustrating for him that would be "conservative" in fact the problem had reduce
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
