Posted by DoubleO7 on September 20, 2020 at 12:01:26 from (75.115.42.50):
In Reply to: Will this work? posted by flying belgian on September 20, 2020 at 10:42:00:
Thats why in the other thread on this I asked:
"How deep is the line? (4" to 6" dirt above tile means it is plugged up with roots from whatever is growing near it. I bet there are a lot of " healthy" plants)
And are you sure the end is not where it is bubbling up?
You might be off by 10%?
It could also mean that your tank has been letting solids, paper, washer lint and you know what into the lines. And all of those particles have been filling up the voids/holes/slits in the line as well as the media around the lines.
The line is not yet plugged but the effluent no longer can get out of the lines like it use to and is bubbling at a point of least resistance.
Some effluent is still seeping out elsewhere but not as fast as it once was.
Same thing can happen with too shallow lines and plant roots filling up the voids/holes/slits in the line as well as the media around the lines
Trying to drill a bunch of holes thru the drain line would be tough to do. Are you going to move the dirt off the line to do it?
Your drill bit will likely slide off to the side 95% of the time.
And the the holes will be a waste of time if line is plugged up stream anywhere.
Where are you located? Must not be where frost goes deep or your drain field would freeze up solid every winter. Well south of mason dixon line?
Might want to have your shower/bath/sinks/softener/non toilet lines go into a seperate drain field.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
