Posted by Adirondack case guy on September 25, 2020 at 17:57:22 from (74.76.16.33):
In Reply to: Started soybeans posted by tomstractorsandtoys on September 25, 2020 at 16:40:15:
The cousin started here yesterday. We have only had .02" of rain thus far in Sept. Beans test at 12.4%.
I took this picture from same location 20 days ago. (Oops see pic further down). The beans dried down incredibly fast with the lack of rain this month, but we were lucky and got some nice rains earlier when the crops needed it.-------Last year it was impossible to get beans dried down and lost some due to snow. Hoping for good weather for next 10 days and beans will be done. Corn is looking real good also. Ears dropped and husks opening up. We hoping to have our cake and eat it this fall. I tried plowing last week but ground is way too dry to moldboard plow oat ground. Finished baling the last of the 3rd cutting earlier this week.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
I took this picture from same location 20 days ago. (Oops see pic further down). The beans dried down incredibly fast with the lack of rain this month, but we were lucky and got some nice rains earlier when the crops needed it.-------Last year it was impossible to get beans dried down and lost some due to snow. Hoping for good weather for next 10 days and beans will be done. Corn is looking real good also. Ears dropped and husks opening up. We hoping to have our cake and eat it this fall. I tried plowing last week but ground is way too dry to moldboard plow oat ground. Finished baling the last of the 3rd cutting earlier this week.
