Posted by Roger Tomfohrde on October 01, 2020 at 19:07:49 from (167.177.39.9):
In Reply to: Narrow front tractors posted by Ellis Kinney on October 01, 2020 at 07:04:50:
Probably the biggest reason they went away is it cost more to manufacture a narrow front tractor next to the farmers do not want narrows for serious farming now. A lot more were mentioned below about tires and weight carrying capacity. The last new generation Deere that a farmer showed me a few years ago had independent front axles on four wheel drive so all four stayed on the ground at all time even when the back was not level, took a lot to get one up. I had a tractor that the rear tires(15.5X38) are smaller than the new fronts on some. I have run both but will tell you a wide front is more secure on hillsides against all the naysayers here. The only tractor I come close to tipping(had a back wheel 8-10 inches off the ground) was a 460 with a narrow and a 2001 loader on it, ran over a pocket gopher mound. My uncle tipped a Farmall 340 narrow over twice. Plowing with a narrow lifts the front several inches more than a wide. I have planted corn on hill sides you needed to drive on the last row you planted to get the rest uphill far enough. We mowed road ditches for hay every year from the 60s into the 90 when we had cattle. Something's you had to do if you wanted to keep farming, but you had to be careful. Like I said manufacturing costs and lack of need made them quit, just like making 2 row equipment.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Lifetime of Farm Machinery - by Joe Michaels. I am a mechanical engineer by profession, specializing in powerplant work. I worked as a machinist and engine erector, with time spent overseas. I have always had a love for machinery, and an appreciation for farming and farm machinery. I was born and raised in Brooklyn, New York. Not a place one would associate with farms or farm machinery. I credit my parents for instilling a lot of good values, a respect for learning, a knowledge of various skills and a little knowledge of farming in me, amo
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.