This item as was noted is a safety retrofit and will not show up in the original parts diagram. That part is unlikely to be your problem. It is a simple circuit breaker. It is a normally closed device which I believe in normal operation (just setting there) will show 12 volts to the tractor frame on both sides or zero ohms if you remove the wires and test it. Trouble shooting the solenoid on a 24 volt system is a little different process. The first thing to do is to make absolutely sure the tractor is in park. Checking the solenoid starting circuit with reference to the tractor frame will give you confusing results. I would thourly check the neutral safety switch, remove the connector and check for zero ohms. I would also remove the solenoid from the starter, dissemble it and inspect the contacts. If it is old or has been run with low batteries I might replace it. I know it costs around a $100.00 but if it welds itself internally when starting you may ruin the starter before you can disconnect the batteries. With all that said poor starting in a 24 volt system is usually batteries and/or connections. Take forum advice from individuals who understand the system, it is different. Tx Jim is a good source.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Lifetime of Farm Machinery - by Joe Michaels. I am a mechanical engineer by profession, specializing in powerplant work. I worked as a machinist and engine erector, with time spent overseas. I have always had a love for machinery, and an appreciation for farming and farm machinery. I was born and raised in Brooklyn, New York. Not a place one would associate with farms or farm machinery. I credit my parents for instilling a lot of good values, a respect for learning, a knowledge of various skills and a little knowledge of farming in me, amo
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.