Posted by Eldon (WA) on October 09, 2020 at 23:04:35 from (98.247.104.61):
In Reply to: allis roto baler ? posted by swindave on October 09, 2020 at 07:18:28:
Quoting Removed, click Modern View to see
That was our only baler in the 50's, 60's and 70's. We would put up around 12,000 bales some years. Ours had the hi-speed wrap mechanism on it that saved a lot of time. Think of a square baler cutting every bit of hay that went thru it and you can see how much more efficient a round bale was. It could be left out in the field and would shed water unlike a square bale that became a big sponge. When I was 10 years old my job was to rake the perfect windrow while dad baled. Then we started stacking them in the field, starting with a 4x13 bottom layer and building up a pyramid, I swept up the bales with the WD45D and Du-all loader with hay basket, my sisters stacked them. In the fall we hired a guy with a Lahman stack mover to move them home. He would wrap a chain around the bottom layer, the back under them. Worked good, but those stacks were heavy, I think about 304 bales if I remember right. That baler still sets in the trees on the old farm, I inherited a newer white top that my dad bought after I had gone off to college...it is still in the barn in South Dakota and is for sale....
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
