Posted by Destroked 450 on October 11, 2020 at 06:36:01 from (66.38.93.182):
In Reply to: allis roto baler ? posted by swindave on October 09, 2020 at 07:18:28:
One did do a lot of stopping with one of those balers but it was a perfect match for a WD Allis with it's trip forward hand clutch, one simply pushed forward on the clutch handle till it released, then the handle would fly forward stopping the tractor, once the bale was wrapped and ejected you pulled the handle back until it snapped into place reengaging the clutch.
Dad had ours set to make 100 lb bales, we used it to roll up second cutting hay and leave it in the field, cows where turned in to the fields during fall and winter to forage on the grass but the bales were to tight for them to eat on.
Each day we'd cut ice on the ponds and chop open a dozen of those little round bales, cows would clean those up a be waiting for more to be chopped open the next day.
Although it took time to make those little round bales they saved a lot of time and labor not having to be hauled and stored, then be hauled back out to be feed.
For beef cattle they were handy little balers, for dairy operators probably not so much.
As others have said the large round baler put a end to the Allis Roto-Baler.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
