Posted by kcm.MN on October 29, 2020 at 12:41:22 from (174.219.148.253):
In Reply to: Shop Stove posted by vicinalvictor on October 29, 2020 at 11:37:36:
Rocket stoves are not normally meant for heating such spaces. Think of them kinda like a huge match on steroids - they burn very hot and very quickly.
There are designs that other people are dreaming up to make rocket stoves last a longer time....kind of a hybrid. And there are others that are meant solely for the purpose of providing long-lasting heat. These are called Rocket Mass Stoves, or Rocket Mass Heaters. They work by pumping LOTS of heat into a rock or cement or similar mass very quickly, that mass heats up, then gives off its heat over several hours. It sounds like a great idea, but.....there always has to be a 'but'! But, that heat often is not released quickly enough to keep the room warm. Might also be that the 'mass' cannot absorb all of the heat from the stove.
If you're looking to keep a shop warm (especially for 8 hours or more), I highly recommend dumping the idea of rocket stoves and going with something more traditional.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
