Posted by Brian G. NY on November 06, 2020 at 07:42:45 from (154.27.219.240):
Didn't want to hijack the other thread so I started a new one.
MeAnthony wrote:
Wow, that must have been something to see! :
Why would it only work with DC? You're basically creating a short circuit in which the pipe becomes the conductor/resistance/heat source, right? Essentially the same as a light bulb works but on a heavier scale? Not trying to dispute your statement, just trying to learn and understand the "theory of operation".
Thanks!
It was something to see........as a kid, I remember seeing this a few times. A local mechanic, welder, TV repairman, etc., etc. used to hook his old DC welder up to the back of his car and take it to where ever someone needed their pipes thawed.
Many homes and barns were fed from springs with long underground pipes. With so much plastic being used to day, you're not likely to see this much anymore.
His welders were all hand built by himself from large generators.
I remember one was powered by a Model A engine and another with a 6 Cyl. engine out of a '36 olds.
Of course, these were DC welders.
Why AC would not work, I haven't a clue.
My Dad had a Forney AC welder which came with a "carbon-arc" torch for heating. You could also clamp the carbon electrodes to each side of a frozen nut and the nut would turn red in very short order. So, why wouldn't AC work as well as DC for thawing pipes?
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoring a John Deere 2010 Diesel Tractor - by Jim Nielsen. Following seven years working in California's Silicon Valley, my wife, baby son and I moved back to Australia to retire. We bought a small 'farm' of about 50 acres near Bendigo, in the state of Victoria. I soon found that it would be very useful to have a tractor around the place for things such as grading our long drive and brush-hogging the fields. I was also embarking on planting 1000 eucalyptus trees, and hence I would need a ripper, small disk plow, sprayer etc. to get these things accompli
... [Read Article]
Latest Ad:
1945 Farmall wide body gas with pto and front plow. Runs good but needs new points.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
