Posted by Steve@Advance on November 22, 2020 at 06:51:13 from (66.169.147.211):
In Reply to: belt power equipment? posted by swindave on November 22, 2020 at 05:26:39:
I've never run one either, watched it done at tractor shows.
It works well if the operators know what they are doing...
I've maintained a lot of conveyor belts. Most run with no problem, but some that don't have the crowned rollers area constant battle to keep them tracking in the middle.
One place had a multi bank drill press with flat belts. Constant problems! To keep the belt from slipping it had to be tight. But run it too tight and the lacing would pull out!
Belt drive was how everything was run in the old days before electric motors. Entire factories ran off a common shaft with a belt for each machine.
There is a cotton gin museum near here, it is set up like that. They start up the old Bessemer diesel and run it once a year.
What a nightmare that place would have been! Hundreds of belts, shafts, pulleys... Hot and nasty! They said working the night shift was more desirable because of the heat. Fire was a constant threat. The dust and lint were highly flammable. The belts generated static, a hot bearing could bring disaster!
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.