Posted by super99 on November 22, 2020 at 06:58:51 from (184.20.245.17):
I have a 50 x 80 metal arch building. I want to work on a tractor inside this winter, but anytime I have tried to add some heat, the moisture from the metal rains inside. I thinking about making a shelter inside that I can heat and protect from getting rained on. I looked at portable garages, Menards has a 13x20x10 high shelter for $436 after rebate. I know that lumber is skyhigh right now, I'm wondering about using conduit to make a frame and then get one of those billboard tarps to cover it. This isn't a 6 days a week, 10 hours a day deal. When the weather is above 20°, I just want a place I can add some heat and work with my gloves off 5 or 6 hours when I feel like it. It doesn't have to be huge, but I want enough room to work, I have a one car garage that is heated, but I put the Oliver 550 in it last winter and there wasn't enough room to walk all the way around it. I need to do an inframe overhaul on the IH 400 or else work on the 88, haven't decided which one yet. I'll admit it, I'm cheap!!! Looking for ideas for what I want to do. Thanks, Chris
This picture is to show the inside of the building, I won't be using the hoist inside the shelter.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
1945 Farmall wide body gas with pto and front plow. Runs good but needs new points.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
