Posted by DeltaSteve on November 23, 2020 at 07:41:44 from (67.41.193.199):
In Reply to: front end loaders posted by Texas Tuff on November 23, 2020 at 07:19:05:
Not at all familiar with your tractor.A lot of loaders are 'universal fit'. Some can be made to fit useing some ingenuity .Cousin looked for two years for a loader for his 1085 Massey as there was nothing out there used that would fit. Finally was ready to to buy new when he stumbled onto a practicly new loader on a 'junk' tractor.Anyway, he bought the whole outfit. He had it delivered to my place,Had me hepl swap tractors. Then he left the old 'junker'(acctually,it really wasn't 'junk') with me to sell.Several months later a man stopped in looking for a tractor.Showed it to hom,told him the story.Said he would take it,but wanted to trade an 8N Ford in on ot. Said "I cant,this Massey doesnt belong to me".So,long story short,A 'three way' trade ensued. I wound up with a nice 8N with a rebuit motor for $500.Still have the Ford.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
