Posted by paul on November 23, 2020 at 15:36:25 from (76.77.197.114):
In Reply to: 3 point hitch pins posted by OregonAaron on November 23, 2020 at 15:19:26:
Cat 1 is up around 50+ hp.
Cat 2 is 60-120 or so hp.
Cat 3 is the big tractors, and then when the super big tractors came I think thry went to cat 4 even?
Each one has bigger pins, is wider between pins.
Except, then they came up with the Narrow, or N, sized. So a cat 3N has big pins like a cat 3, but they are spaced as wide as a cat 2. So you can start using the same quick hitch with adaptors on different equipment.
If this sounds confusing, it is. There are about 6 different common possibilities.
Anyhow, if you have a cat 1 blade and you put it behind a cat 2 tractor, they make little sleeves, short pipes, you can put on your pins and work with the cat 2 tractor. Or you can buy bigger pins, but then you have to find the type with the smaller threaded side to fit the holes in your blade...... some folk just let the little pins rattle around in the bigger holes on the tractor arms.....
Your tractor likely has some sway chains or metal blocks or a bar with pins on each side that can be set differently for the narrower cat 1 width of your blade.
Now using a cat 1 blade with a cat 2 tractor is likely to greatly shorten the life of the blade, since it was designed for lower hp use, and now you can pour the wood to it and really scoop a load with it, more power as Tim Allen would say. With similar end results.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Cautionary Tale - by Ian Minshull. In the early 1950s my father bought an Allis Chalmers B and I used it for all the row crop work with the mangolds and potatoes, rolling and the haymaking on our farm. The farm and the Allis were sold and I have spent a lifetime working on farms throughout the country. I promised myself that one day I would own an Allis. That time event
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.