Posted by DR. EVIL on November 25, 2020 at 08:56:44 from (174.192.134.238):
In Reply to: Re: Handy hint posted by flembo on November 24, 2020 at 10:58:07:
I wasn't running the lathe doing the tapping, but one bar out of 3 semi-trailer loads of 4" 4130 aircraft quality cold drawn steel bars broke a 2"-4-1/2 threads per in tap off, turned bar around, drilled and tapped other end and broke a second tap. The shop managed to break up the remains of the tap and got it threaded deep enough without breaking a 3rd tap. The other end they welded a plug in the hole and ground it smooth. Then the tapped around 150 more bars with that 3rd tap.
Hammer pins for automobile shredders, think of a hammermill feed grinder 8 ft wide by 7 feet in diameter. And we made bigger ones too. 8 ft diameter by 9 ft wide.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.