Hi Bill, it’s always nice to watch a baking video especially if there’s an MF involved. The bale kickers never caught on in the U.K., in fact I don’t think that I have ever seen one here. The popular methods over here were lift each bale by hand and pike onto a flat-bed trailer with someone stacking, then came a towed sledge that could be tripped to drop 8 or 10 bales in random order for hand loading onto a trailer or stacked into 6s or 7s for a squeeze type grab commonly called a Perry loader. Flat-8 grabs and sledges then came along and made it easier. One of the conveyor types and similar to one seen on a US video had a largely enclosed trailer and an elevator attached to the trailer. The elevator followed the line of bales and dropped them into the trailer. A rare sight over here was the New Holland ‘merry go round’ but that was really limited to larger farms and was problematic. On our 10 acres we had a 16 bale squeeze made by Browns. Bales were stacked into two blocks of 8 or 9 and could be picked up independently. It was a great system for us as I could drop 16 bales at the foot of the elevator, the person loading the elevator would not be under pressure to move the 16 quickly and would have a few minutes breather before I brought the next load. This works fine if the barn is in the same field or very close. DavidP, South Wales
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
