Posted by sotxbill on December 06, 2020 at 07:51:09 from (104.5.24.112):
In Reply to: Engine stand posted by svcummins on December 05, 2020 at 23:17:50:
two comments from using them..
IF... you mount the engine with the rear arms CENTERED,,, it will then spin over easier... if you just mount the engine in the lowered position, it will be very very hard to spin over.
AND,,, if you look at the entended legs, and where the wheels are mounted on the floor.... those wheels are the center of gravity point as to where it will flip over... so the engine would have to stick out more than half of its length past those front wheels... That would mean your engine would need to be nearly 7 feet long to flip...merly sticking out 6 inches or a foot past the those wheels, with 3 feet plus on the other side will not tip it.
And yes, you dont use this on an incline or rough floor.. Actually you probably should not move the stand once an engine is mounted.
getting the block centered, and then adding the heads to it, can make it harder to spin, so I always add the heads last thing in the assembly process. I always use the long pipe (jack handle) to spin the engine. there is a place to store the pipe on the stand.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Upgrading an Oliver Super 55 Electrical System - by Dennis Hawkins. My old Oliver Super 55 has been just sitting and rusting for several years now. I really hate to see a good tractor being treated that way, but not being able to start it without a 30 minute point filing ritual every time contributed to its demise. If it would just start when I turn the key, then I would use it more often. In addition to a bad case of old age, most of the tractor's original electrical system was simply too unreliable to keep. The main focus of this page is to show how I upgr
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
