Posted by grhuck on December 11, 2020 at 13:12:18 from (24.123.236.18):
In Reply to: John Deere R posted by TDJD on December 10, 2020 at 14:16:38:
Quoting Removed, click Modern View to see
The two companies that made FIPs for the old 2 cyl Johns were Bendix and American Bosch. To the extent that Am Bosch is still in business they no longer manufacture spare parts for those old pumps. and certaily Bendix does not.
The aftermarket companies that are making parts for these don't have the best quality control.
There is a special made double bevel, copper washer that either Am Bosch or Bendix (maybe both) used to seal the delivery valve to the dely valve holder. In particular, it is difficult to get one of these aftermarket washer so seal. Likely your rebuilder didn't take enough time pressure testing the pump(s). Our old tool and die guy said that the defective washers were made with bearing bronze and not copper and didn't have enought crush to conform to the sealing lands.
He hand turned out a bunch of these copper washers on a lathe that we used in the shop I work in. Sadly the tool and guy died and the washers have all been depleted.
Ask your rebuilder about this. We did get the bronze washers to seal it just took a few tries.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
