Posted by Jim.ME on December 20, 2020 at 04:40:07 from (67.242.178.40):
In Reply to: Micrometer reading 101 posted by svcummins on December 18, 2020 at 13:28:20:
The edit feature does not work presently, due to issues between classic and modern views I believe, and has been discussed many times.
I already asked that question and SV has answered it. One turn moves 25 thousandths. The last picture of a General #102 mic is one I posted it to show the difference in the thimble graduations. That is one I consider graduated in thousandths on the thimble, with 25 marks around the circumference.
From the picture of the packaging I am guessing it is a General, that is not confirmed. General provides some good tools, at a reasonable price, which meet the needs of many. I have some of their tools, so I am not bashing them.
Some research of images reveals General had some, like SV's, with 50 marks around the thimble (with travel 25 thousandths per revolution). I call that graduated in .0005", even though packaging says graduations are .001" (Its not graduated in millimeters). Research also found General also had some carbide faced mics at one time. They may not have actually produced all the mics they sold. They may have had some branded from other sources, which could axplain the differences over the years. Many brands of "cheap" mics have .0005" graduations and carbide faces, so price doesn't always control what you get. Many are surprisingly accurate, at least in the beginning. How accurate they, or any mic, remain over the years can only be checked by regular calibration. I have seen "cheap" mics pass calibration and "expensive" ones fail.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - Tractor Engine Repair - by Teri Burkholder. One of the great things about working on a tractor engine with your other half is that you know what he is thinking of at all times and can anticipate his every move and his next thought of what he will do. With Ben, anyway, I can tell! He'll be busy working and I’m handing him tools and he says, "give me that..." and I’ve already got it in his hand or "hand me that....."and I’ve got the portable light right where he needed it placed to see. "Run in the house and get me a...."as I open th
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.