Posted by Dieseltech on December 25, 2020 at 08:29:07 from (64.184.64.50):
In Reply to: Massy 1100/1130 power? posted by Al Baker(pumpman) on December 25, 2020 at 08:02:32:
Plow size depends on soil type AND how fast you want to plow. Dad pulled 6-16 MF 880 plow with his MF 1100 he bought new from the MF dealer I worked for years ago. I had an 880 7-16 on land plow I pulled with an MF 1105 8 speed using third gear. Dealer also had one 1130 owner that was using an eight row twenty inch chisel planter in the 70s. The hydraulic system is closed center similar to JD also. Most were sold with the 12 speed MP transmission option, with six speed standard. the eight speed option started with the 05 series. Far as plow size goes, there were no 8 bottom MF plows in my area, and I remember plowing speed was slower when I was a kid too. Going from a 2-16 to 3-16 plow is a 50% increase, 6-16 to 7-16 is about 17% increase when you compare plow size that way.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
