First cutting has heavy stems that don't dry down that easy against wet ground. I want to see day time highs in the 80's before I start cutting hay in late May or early June. I don't want to wait too long because it'll screw up second and third cutting timing. I want the moisture to drop to below 10% in the windrow during the day and rehydrate with humidity in the overnight hours. First cutting can usually be baled between 11:00pm and 3:00am
Second cutting in July and Third in late August are probably the most challenging. It's not uncommon for us to have highs upper 90's and drop below 20 percent humidity during the day. The windrows dry to 0% and the stems are fine. When this happens you need everything the night will give you in terms of cool temps and humidity. We can cool off at night into the 50's and get up to 70% humidity in the early morning hours. I will get out at 3:30 am to start baling on second and third. If we get any wind like 8mph or more you are going to be baling dry hay. I want 18% in the bale and will push to 20% and let it drop to 12%. There are always compromises.
I use a weather station to monitor humidity and temp over night. When the hay is 0% in the windrow, you need a good 4-6 hours above 50% at night with no wind and low temps to get the moisture right. I can bale at sun up, but about an hour after the sun comes up the air starts to stir and the wind works against you.
I can access this weather station from my iPhone and keep track of time and wind speed.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Listening to Your Tractor - by Curtis Von Fange. Years ago there was a TV show about a talking car. Unless you are from another planet, physically or otherwise, I don’t think our internal combustion buddies will talk and tell us their problems. But, on the other hand, there is a secret language that our mechanical companions readily do speak. It is an interesting form of communication that involves all the senses of the listener. In this series we are going to investigate and learn the basic rudimentary skills of understanding this lingo.
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
