Old farmer I helped back in the 70's did things the old fashioned way. He used an IH W-4 on a belt to power his buzz saw. To fill silo he had an old table blower that he ran with the W-4 and endless belt. He put sides and a back door on his flat bed wagons and backed up to the blower. He had a head board with cables back to a pipe on the rear of the wagon. Then an small electric gizmo with a shaft that turned the pipe. We stood on the other side of the blower and used potato hooks to help drag the silage into the blower. Its a wonder I still have all my fingers and toes. He quite running his real nice thresher in the mid 60's when his half wit nephew got run through the belt and thrown against the thresher. I remember him telling me that the kid was not breathing when he picked him up, so he shook him hard and got him breathing again. Great memories, but an awful hard way to make a living. He raised 5 kids on a 100 acre farm milking 25 cows. Carried the milk in pails out of the barn into the milk house, even after he had a bulk tank. I bought an old W-4 myself a few years ago for the heck of it. The old guy who owned it had died. But he used a really big pulley to run a front mounted buzz saw with it. The saw was gone by the time I got the tractor.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
