Posted by Mike Cleary on January 16, 2021 at 11:07:20 from (216.180.214.67):
Hi. A couple years ago, I bought a power steering cylinder, on Ebay, that was from a "76" vintage Fiat 460 tractor. I recently took time to do this project. I made up the brackets, hoses, power steering pump to fit it on my B414 international with a loader. Everything went smoothly till I started it up! It made a hard left turn and stayed there. I had to jerk the steering wheel hard to get it to come back, but it then made a hard right. I found that the shuttle valve was sticking badly. When I pulled it apart, I found the hardened sleeve in the valve was broken in the middle, causing the shuttle to bind up.
In looking for a replacement or parts, I find these to be pretty much non-existant. Does anyone have an old cylinder, with a valve that is not froze up, that they might part with? Otherwise, I guess I take my losses and start over.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.