Posted by Hobo,NC on January 19, 2021 at 04:31:56 from (75.137.54.152):
In Reply to: Cheap screw drivers posted by svcummins on January 18, 2021 at 19:25:12:
My go to is Vessel
Megadora 980 Impacta P2x100 #2 Cross Point Impact Screwdriver.
Uniquely designed screwdriver and impact driver in one
Fits #2 Japanese Industrial Standard (JIS) and US Phillips screws
Proprietary cam mechanism rotates the shaft 12 degrees with each hammer strike
Magnetized black coated tip
Its a must when working on Asian cars it fits Phillips as well. JIS another issue thrown into the mix...
I have snap-on, Mac, Matco, SK and GEARWRENCH I use the GEARWRENCH 6 Pc. Phillips/Slotted Dual Material Screwdriver Set - 80050 95% of the time. When going after a Phillips I grab a grearwrench and a Vessel. The Vessel will get what the others will not fit well no matter what style they are. Its rare I have to hit the Vessel with a hammer when I have to its a life saver.
Why so many, in my trade it takes quite a few lengths from 9" up to 28" to get'er done... Add a Vessel to the litter it will impress ya...
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
