Posted by Hockeygoon on January 19, 2021 at 18:47:59 from (68.171.183.80):
In Reply to: Re: F150 3.0 V6 posted by Old Popper on January 19, 2021 at 08:19:39:
The 3.0 Vulcan engine first came out in 1985 - through its entire life from carb to electronic fuel injection it always had about 145 to 155 hp. The 3.0 diesel is a European design was taken from the "Lion" engine lineup produced by Ford in the UK (also used in PSA Peugeot Citroen and Jaguar Land Rover) - it has nothing to do with the old gas Vulcan engine.
One thing I just learned was the cam shafts are driven by belts - not chains..... Ford is "hoping" they fixed several design flaws with a new forged crank shaft and new crank bearings.
I've never been a fan of the "new" light duty diesels in the US - the emissions requirements in the US ensure there is no reliability with these engines no matter the make.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
