As said before I mainly use torx T-25 screws but some of the shorter ones come in T-20 and cabinet head torx in T-15. I've pulled some out of treated wood that have been in for 15 years and they come right out. I have occasionally got some soft drivers that will strip out after a while especially if not engaged straight up and down but I look for the better quality ones.
The only other thing I use are the hex head type barn screws. At least those don't strip out. Have an electric impact wrench for putting barn tin on roofs and siding.
I used the square head stainless or aluminum (I forget) screws that were recommended for a composite deck going in treated lumber underneath about 15 years ago. Had to remove a number of boards last summer to change things around. A lot of those square head screws either stripped out or broke off. Use vise grips to get the stripped ones out or just pried the board up screw and all. Now I need to go look to see if the screws were the tapered Robertsons or the straight square ones. And then look to see which bit I was using as I didn't know there was a difference. As I recall, the bits had a taper and if the screws were not the tapered ones then that may splain things. Will check them later today.
I just know that Phillips will automatically strip out either going in or coming out of treated lumber unless using extreme down force to keep them seated and then go slow and use a start and stop with the drill to maintain the bite and avoid cam out when hitting a tight spot.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Grain Threshing in the Early 40's - by Jerry D. Coleman. How many of you can sit there and say that you have plowed with a mule? Well I would say not many, but maybe a few. This story is about the day my Grandfather Brown (true name) decided along with my parents to purchase a new Ford tractor. It wasn't really new except to us. The year was about 1967 and my father found a good used Ford 601 tractor to use on the farm instead of "Bob", our old mule. Now my grandfather had had this mule since the mid 40's and he was getting some age on him. S
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.