John Deere made two different bill hooks. One for sisal and the other was called all twine which could use plastic. On my 24t we switched to 7200 many years ago and it only misses when changing balls of twine. Check the hay dogs and springs to make sure they are good and the tucker finger adjustments like mentioned below. Finger Lakes Equipment in New York makes a tucker finger update kit that uses ball joints on the linkage and if you bale a good bit of hay it might be worth checking into. Make sure the twine knife is sharp and the wiper arm is set to wipe nice and tight. On the newer wiper arms that is adjustable but on the older parts you need to bend the arm. Deere had a tool to help with that. Check bill hook for wear and grooves. You might have one big problem or several small adjustments. The 24t manual gives very detailed directions on knotter adjustment. I also added plunger extensions to my 24t. Deere recommended them for straw and loose springy crops. They just push the slice of hay a little further into the baler so when it ties there is less spring back pressure on the knot. Tom
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
