Here in southern MN we have had 5 years of very wet weather.
Hay is sort of a ‘waste’ crop locally, it’s all corn and soybeans. Hay comes from road ditches and ground too wet to farm, but it dries up a bit in June to maybe cut hay.
The previous 4 years were so wet, and then we had hard winters, that hay was really short. Even just average hay was bringing 4-5 bucks a bale.
Now this past summer was also wet, but we had a dry spring, so that first cutting got made off those wet areas for a change.
Then we had a nice long fall, not much snow into January, so there wasn’t as much demand for hay.
So the auction prices are back to $1.50 a bale. Even saw some nice alfalfa go for $2.50 a bale.
Just no buyers this winter.
We got some snow now, and we are in a bitter cold snap, that might accelerate hay use and bring out a few more buyers. Up here in the tundra there is a long ways until green up yet.
But, yea, the hay market is dead around here too again.
Could use that drought locally. Dry up some of that excess water around here.
Something that might not apply to you, but around here, with the higher corn and bean prices, anything that can be planted to row crops will be, won’t be extra little corners of hay for 2021. So that might cut into next fall supply somewhat.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.