Posted by MarkB_MI on February 10, 2021 at 06:42:12 from (174.230.0.171):
In Reply to: Diesel run a way posted by Steve Metcalfe on February 10, 2021 at 06:26:40:
There are a number of things that can cause a diesel engine to "run away". In general runaways happen when fuel enters the combustion chamber and can't be shut off. It could be entering via the injectors, or it could be ingested through the intake. A common example of fuel ingestion through the intake is if someone cleans an oil bath air cleaner with gasoline or solvent and doesn't get it dry afterwards.
My dad and his crew experienced a runaway D7 Cat engine nearly fifty years ago after they overhauled it. My dad wasn't happy with how he thought it was pulling and decided to mess with the injection pump rack while it was running. This turned out to be a colossally bad idea, as the rack became unhooked and all four injectors screwed full on. This tractor didn't have a functioning fuel shutoff and they always stalled it to kill the engine. Dumping the clutch with the transmission in gear simply blew the clutch out. At this point they figured the engine, which normally ran around 1100 rpm, was turning over 7000 rpm. After a couple of very harrowing minutes, they managed to pinch off the fuel line and kill the engine. The motor was pretty much trashed; Dad found a old irrigation pump motor to replace it. That dozer is now owned by the son of one of the men that was there that day, and he still uses it.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.