Posted by Coonie Minnie on February 11, 2021 at 05:36:41 from (50.123.238.137):
In Reply to: Re: Grinding feed posted by jon f mn on February 11, 2021 at 05:02:47:
I'm trying to get the most from the corn I feed... with dairy, passage rate is fast as cows will eat 60 lbs of DM per day. Fine grinding makes for better availability with less coming through the cow undigested. Dairy also has more forage typically than a finishing steer, which helps buffer the "hot" corn.
A steer diet would typically be a lot of more coarsely ground corn and some minimal roughage. I'd argue that in today's world of $5 corn that a steer feeder might be better off with more roughage and finely grinding, but I'm not a steer guy, and I'm sure they'd tell me how little I know.
I typically feed 3-4 lb of ground wheat per head per day... it is a little faster digesting than ground corn, and seems to boost our protein test. It's also a good market for my wheat, as the cows don't dock for test weight :)
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
