Posted by cjunrau on February 18, 2021 at 11:25:10 from (69.158.246.173):
I don't know how , or should I say WHY do Texans put there pluming in the attic of a house above the insulation. Now I'm not saying all houses are this way but I know of some. Here in the far north LOL we insulate to keep heat in in winter and to keep heat out in the summer. Now Texas would insulate and Build to keep heat out and cold in all year round. or almost. Now I understand that they use a spray foam insulation for most house. I may be wrong. around here it costs alot more to use spray foam but it is 10X better than fiberglass. If a house in Texas was insulated to use as little electricity as possible to cool it would they not be better off using the same amount of insulation we do. or is electricity that cheap there that they don't care how much it costs to cool there houses. A house that is built to keep cool should not be that hard to keep warm. I have a 1800 SQFT 2 story house and use no heat in winter if the temp outside is 0 Degrees F and the sun is shining. If it's cloudy The wood stove goes. I have no electric heat. I built the house myself and am a poor carpenter, there are places the wind blows through. If I use no heat at all my pipes would not freeze for a few days even without the wood stove. So that leaves me wondering do they actually not build a house well and insulated in Texas and why would they not to keep the cold in in summer???
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
