Posted by Geo-TH,In on February 19, 2021 at 14:06:10 from (174.202.97.109):
In Reply to: Frost seeding posted by jm. on February 19, 2021 at 13:40:11:
Jm, I'm not an expert here's. One early December day, I used some fill dirt to repair a small section of the yard. After leveling the dirt I used a 3 ft wheelhorse disk to put groves in the dirt. Spread lawn seeds by hand. Next day winter set on . Cover seeds with snow. I thought the worst. Next spring after the ground warmed up I had the best lawn you could ask for. The groves made by the disk is where the seeds ended up. Like I planted seeds in a row.
That said seeds need to be covered with a little dirt or packed a little. I would use a culitpacker after ground thaws.
Next week will be above freezing temperatures for first time in a spell. Next week they are adding days of rain too. So I have about 8 inches of SNOW on top of frozen ground and add rain. The water isn't going to soak in, it's going to run off . That potentially would wash seeds away.
Again I'm no expert when it comes to grass. One reason I like zosya grass in lawn . Get it started and it's good to go.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
