Posted by Case Nutty 1660 on March 10, 2021 at 04:34:17 from (75.127.27.79):
In Reply to: Re: I bought a new rake posted by Bruce from Can. on March 10, 2021 at 02:43:32:
I will buy a new Vermeer carted wheel Vee rake hopefully in the next year or two, I have ran this one since new starting in the late 80's,, I have had to rebuild the main pivot areas a few times since,, and have starting to replace teeth as they get years one them,, very little repairs though in all those years of use, I used to use it on 2500 acres but have cut back to around 700 acres a year now days, as i round bale 99.8% of my hay I will use nothing else but a VEE rake, I like the hyd roll bar VEE rakes too but do not care for the slower travel speeds they need unless you want to break them in pieces here,, 5 mph or so and you are fine here, I run 10-12 mph with my wheel rake, and they wheel types cost a fraction of the roll bar types,,
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
