Posted by bc on March 11, 2021 at 21:54:28 from (24.255.129.137):
In Reply to: Plastic Repair posted by pburchett on March 10, 2021 at 10:45:40:
I've played around a little with plastic welding. I can say plastic welding cracks in the bottom of a stock tank didn't work.
If you can find a little piece a quarter inch wide or so and longer than the crack that you can cut off from another place on the part then you have the same kind of plastic to lay on the backside and and melt it in.
I've taken the torn end of a hanging bumper cover, drilled holes, and used flat head stove bolts with flexible plumber's coil and stitched it together.
Drove down the interstate Wednesday and saw the whole rear clip of a car laying on the shoulder and the cover was in the median. Wonder if it fell off and they didn't even no it. Seen one fall off before years ago and the kids didn't stop. I followed them for a few miles and they finally pulled over at an exit. Told them they lost their rear end laying in the middle of the interstate and they acted like they didn't care. Texas tags, probably stolen for all I know.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
