11 years ago, replace the heatpump with a super super efficient model.
Twas... computer controlled, fully variable fan motors inside and out, muti-displacement scroll compressor.
first problem, everytime there was lightning or power variable, making the power surge, the outside unit threw a code to call a technician. I finally learned to simply go to the outside box and throw the breaker which caused the outside unit to reboot... Always in the middle of the night and when the a/c cut off, I got a nudge in the ribs to get up and fix it. grrrrrrr..
Then 6 months after the 10 year warrantee... the inside variable fan motor quit.... $1000 bucks later... got a/c back.... two months later the outside variable fan motor upchucks... Another grand.... Then during the super super 100 year cold spell at 7 degrees, the aux heat strips croak... $650 bucks and thats fixed. still have a compressor that will go next assuming the new better but very very thin high efficient copper coils dont pin hole due to electrolysis. Would seem that building thin wall copper to make the heat transfer faster, limits the life of the coils to a point that some a/c installers are installing sacrificial zinc donuts around the coils.
Short story, the super high efficiency units many not save you as much after all. They cost a lot more up front, but pay you back every a bit every year.
And the engineers were told to make everything last for 10 years... and boy where these guys good.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Lifetime of Farm Machinery - by Joe Michaels. I am a mechanical engineer by profession, specializing in powerplant work. I worked as a machinist and engine erector, with time spent overseas. I have always had a love for machinery, and an appreciation for farming and farm machinery. I was born and raised in Brooklyn, New York. Not a place one would associate with farms or farm machinery. I credit my parents for instilling a lot of good values, a respect for learning, a knowledge of various skills and a little knowledge of farming in me, amo
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.