Posted by cjunrau on March 24, 2021 at 10:00:11 from (184.151.246.167):
In Reply to: Coming to a Cross Road posted by Bruce from Can. on March 24, 2021 at 07:03:08:
I didn't read all the comments : but I know the tie stall does not have to be removed. The problem is you need another building where they spend the day in not tied on. My neighbor just built a biotek to house his cows in. he still milks in the tie stall barn and it is as old or older than yours. He feeds his cows outside and in the biotek. just inside on the coldest days. even then the cows will go outside and eat silage when the 2nd cut hay is inside. He has no running water in the barn anymore for each cow as he thought it would freeze up the pipes. He says the barn actually only freezes on the end where the big door is where the cows come in. They seem to produce enough heat the 2 times a day when he milks them that it stays just above freezing. This might be an option for you and your son if you don't want to go to robotic milking. As far as manure when you feed them outside it ends up in a straw pack and you don't need the big manure tank for storage. If I am right you only have to have a place to stock pile it once a year and let it compost an spread the next year. Because you have your manure all inside now, they require the holding tank as it is kinda liquid. once you move the cows out I believe that part of your problem will be alot easier to deal with for less money. You and I know that the changes they want you to do will not make those cows happier or produce better milk.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
