Posted by Memphis1 on March 29, 2021 at 19:03:47 from (107.77.233.96):
Hello new to the group and looking for some help. My dads 1968 Ford 3000 3-point lift had been getting slower and slower. Then the PTO seal went out as well so I figured I would tackle both issues at once. So I removed lift cover and cleaned both suction and return filters. Replaced the seals on hydraulic piston and new o-rings on supply and return lines where housing comes together. I put it back together with new gaskets and lift still doesnt work with a load on it and only works very slowly without a load Pump is primed however I have not done pressure test. One thing I noticed that may help pin point the problem is if I flip the selector lever to the horizontal position (draft control) and hold it down tightly with the heel of my boot it will lift a 5 ft bush hog Any help would be appreciated before l remove the lift cover again. Also refilled with universal tractor trans/hydraulic fluid from tractor supply to fill plug
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
