The weakest point of any building; especially one with 16 foot walls; is the junction where it connects with the ground. In houses they combat this sheer problem from the wind by skinning the walls with OSB or plywood. Most pole barns are not built to these standards as a metal skin does not meet the sheer performance. So the best advise I can give you if you choose to use these options is to use braces; braces; and more braces.
Now with that said...... I live in a area where the water table is just below ground level. In some places it is above ground level. We call this area a swamp. We still drive wooden piles under slabs of every house for foundations. We still build houses 8 feet off the ground on wood pilings. We still build boat docks where the wood is sitting in salt water 24/7. And we have none of these post rotting off problems at ground level. In fact our fence post are more likely to rot from the top down. Its the reason you see metal cans on top of fence post around here.
Our secret. We still use CCA treated wood. I know it may be hard for you to find but at least look for it. If you can find CCA treated wood treated to 0.80 levels use it. You will never regret your decision. It will give you years of service and with solid poles give you the sheer performance.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
