Just mounted two new tires. Ether was the only way to get them to seat the bead. You need to be ready to shoot the air because when the hot air cools, it can suck the beads back off! Ether with oil in it won't work, at least it wouldn't work for me. I suspect that's what causes people to us too much, because the ether with oil is hard to get to lite off. I always wear goggles. Ha. If a person is afraid, I'm thinking that you could lay a spark plug on the tire and hook it to a fence charger and stand way back and plug in the fence charger. I haven't tried this yet, but it seems like it would work. I think it's more dangerous to air up a tire holding the air chuck. I had a truck tire blow up on me one time when I was holding the air chuck. Luckyly I heard the tire start to make a crackle noise just before it blew! I jumped back just in time before it blew. Sounded like a stick is dynamite!I now only use clip on air chucks and stand back! I have 2, one has the guts removed for seating the beads, and the other is a regular clip on chuck. If a bead doesn't seat by the time you get to normal pressure, don't use much extra pressure! Let the air out and bounce the tire to re a range the beads. Spray some wd40 around the beads. That works well for me.I've been changing my own tires for years. By the way, that hand bead breaker from harbour freight works very well! It takes me about an hour to balance and mount a tire, so I save $20 bucks. Ill work for those wages! A tire shop can probably do it in 15 minutes!
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Lifetime of Farm Machinery - by Joe Michaels. I am a mechanical engineer by profession, specializing in powerplant work. I worked as a machinist and engine erector, with time spent overseas. I have always had a love for machinery, and an appreciation for farming and farm machinery. I was born and raised in Brooklyn, New York. Not a place one would associate with farms or farm machinery. I credit my parents for instilling a lot of good values, a respect for learning, a knowledge of various skills and a little knowledge of farming in me, amo
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.