In Texas,cotton was king and boll weevils were the archenemy. Once weevils appeared they quickly destroyed crops. That meant having tractor fueled and ready with blower mounted and poison onboard. We applied DDT powder with a pto driven blower while dew was on so powder stuck to leaves. Dew only fall's when there is little to no wind. You drove fast trying to stay out of dust but it was impossible to stay clear of the cloud. What would Dept Of Labor and OSHA think today? Here's something most people living around cotton don't know. Most nights during hot growing season,it's much cooler in a field of cotton than other places. For that reason it's the first place dew fall's. When dew dried and dusting stopped, farmers had to check fields for dew during night so dusting could resume quick as possible until all fields have been dusted. Water born spraying replaced dust in early 50s so spraying went non stop until all fields were covered. Airplanes soon started spraying so that sped things up considerably. I have many fond memories of the pilots and planes but few of cotton farming as a whole. Dad went flat on his back with TB in 1946 and was unable to work until he died. I was the youngest at 3 and my 13 year old sister the oldest of 5 kids. When mom passed in 2010 I told people if only we were half the man mom was the world would be far better today.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
