Posted by Jo Bird on May 05, 2021 at 16:35:33 from (50.48.153.121):
In Reply to: Mice eating ear corn posted by Winchester1 on May 04, 2021 at 15:58:37:
Take a 5 gallon bucket , drill 1/8" holes across from each other , take an aluminum soda can drill 1/4" hole centered top and bottom , insert a wire through the can and stretch across the holes in the bucket centering the can on the wire . Fill the bucket 1/2 with water, paint the can with peanut butter , then put about a 3' board for the mice to climb up to the top of the bucket at each end of the wire. Mice will climb up the board, smell the bait and jump out on to the can which will rotate plunging them in to the water and drown ..
For rats take a larger barrel , fill it 2/3 with water , sprinkle some cow feed ( preferably with molasses ) on to the top of the water, install ramps from the ground to the top of the barrel .
Dump out the bodies ,wash and repeat till the problem goes away.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
