Posted by Bruce from Can. on May 10, 2021 at 16:47:09 from (70.51.53.119):
In Reply to: SMV sign mounting???? posted by Tractorcedric on May 10, 2021 at 12:59:31:
I would not buy those brackets, often if you go over a bump, your smv sign will jump out, and you will loose it. Better idea is to weld some flat stock onto a piece of pipe, that is maybe 6 inches long. Drill some holes into the flat stock so you can bolt it onto tractor fenders, or other equipment. Make several of these, and fasten them one the equipment you need signs on. Then using a length of pipe anywhere from 12 inches or longer that will sleeve into your pipe bracket, bolt your smv sign to this pipe. Your pipe on the bracket needs to have two holes drilled through it, best to drill these holes before weld onto the flat stock. Run a bolt through the bottom hole, and put a nut on it. Place your sign which is now fastened on the pipe into the bracket, and drill through the top hole, and through the pipe with the sign attached. Once its done, slid a hair pin clip through the hole, and your sign wont fall off, or get pulled off by a branch without you knowing. You can also be creative and use a longer pipe on the sign with a couple of 90 degree bends one over, one up so the sign is out of your way for field operation, but in clear view to road traffic. Signs dont cost all that much really, and I just bolt them right on to equipment permanently
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tuning-Up Your Tractor: Plugs & Compression Testing - by Curtis Von Fange. The engine seems to run rough. In the exhaust you can hear an occasion 'poofing' sound like somethings not firing on all cylinders. Under loaded conditions the tractor seems to lack power and it belches black smoke out of the exhaust. For some reason it just doesn't want to start up without cranking and cranking the starter. All these conditions can be signals that your unit is in need of a tune up. Ok, so what is involved in a tune up? You say, swap plugs and file the points....now tha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
