Posted by BarnyardEngineering on May 11, 2021 at 09:58:44 from (161.69.121.33):
In Reply to: SMV posted by Tony in SD on May 11, 2021 at 00:35:23:
I thought those things were for marking the edges of your driveway at the road...
Seriously, it doesn't matter what you have, SOMEBODY will plow into the back of you, and if they live to tell the tale, they will wail, "BUT I DIDN'T SEEEEEEEEE IT!"
It's gotten so bad on the highways these days that I'm starting to see police cars with arms that raise straight up in the air, and have a bunch of flashing strobes on them. People will STILL plow into the back of one and cry, "BUT I DIDN'T SEEEEEEEE IT!"
People just don't pay attention, and nothing you do will make them, but with every tragic accident the laws get more and more extreme, and it's always against the farmer, tow truck driver, police officer, etc...
I thought that when you were rear-ended, legally it is automatically the fault of the person doing the rear-ending...
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
