Posted by Pete in Holland MI on May 11, 2021 at 19:21:27 from (66.227.231.154):
In Reply to: Painting H Tractor posted by johnmor on May 11, 2021 at 16:29:18:
Pre-paint any surface that is hard to get to and not necessarily visible (like under sheet metal), then assemble. Acid etching primer is better than red-oxide primer over bare metal. Rattle cans generally are very thin paint and takes effort to build up a coating. It also isn't necessarily the same paint as in the big cans, and often prone to fading quicker.
Iron Guard paint at the IHC stores has been pretty good for me. Holds it's color, and goes on well. Buy their thinner, but Acetone will clean your spray gun. Not automotive, but far better than any tractor paint found at any of the big box farm stores, and around $65/gallon. Give a tac coat, then a full coverage coat. Dries quickly. Can recoat in about an hour or two.
As mentioned earlier, painting a second coat after 24 hours or so from the first coat, the chemical bond will be far less, and layer separation is a possibility without sanding of the first coat.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: 1964 JD 2010 Dsl - Part 2 - by Jim Nielsen. Despite having to disassemble the majority of my John Deere 2010's diesel engine, I was still hopeful I could leave the engine-complete with crankshaft and camshaft-in the tractor. This would make the whole engine rebuild job much easier-and much less expensive! I soon found however, that the #4 conrod bearing had disintegrated, taking with it chunks of the crankshaft journal. As a resul
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
