Posted by used red MN on May 14, 2021 at 08:49:28 from (75.73.112.20):
In Reply to: Re: Grease Gun posted by T in NE on May 14, 2021 at 05:42:38:
T in NE, I would question the quality of a grease gun from Walmart but sometimes their stuff proves out okay. A tip for starting a new tube and I am assuming you have trouble getting it to pump grease again. After you insert the new tube reinstall the head but only one turn. Jiggle it around a little so you are sure the threads are engaged enough to hold back the spring pressure. Release the rod lock then finish tightening down the head. This helps the trapped air escape. You can also turn it a turn and tap the gun pump end down against a wood block on the bench, another half turn and tap etc. All in an effort to get the air out. YTers must be passionate about their grease guns. I see posts on here from members that joined 10 years back or more with post counts around 600 or less. Just a side observation.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
